Skip to main content
All jobs

Job opening

Test Engineer

WashingtonContractAerospace

Section

About the Role

Headcount: 1

Start: November 30, 2026

Employment Type: Contract

Why Hiring

  • Reduce the Test Engineering Evaluation non-conformance report (NCR) backlog by 80%.
  • Reduce the out-of-tolerance (OOT) backlog by 80%.
  • Reduce the Testers in Repair backlog by 80%.

End Product

  • Production electronics include printed circuit assemblies (PCAs), printed circuit boards (PCBs), ACPs, REUs, AMUs, and related subassemblies.
  • Automated test equipment used by technicians.
  • Modern and legacy audio assemblies and avionics assemblies.
  • Production test engineering, not an FAA repair-station bench.

Tech / Domain Environment

  • Debug both the unit under test and the tester.
  • Use Altium for component-level fault isolation and schematic debug.
  • Perform some hands-on board rework using HAKKO soldering stations.
  • ATE work is fixture and setup debugging, not writing new test software.
  • Bench equipment includes INSTEK milliohm meters; Tektronix or Rigol oscilloscopes; Fluke meters and Fluke calibrator; Sorenson power supplies; HAKKO soldering stations; flying probe; and ICT.
  • Circuit topics include microprocessor-based circuits, microcontroller-to-peripheral communication on an SPI bus, and digital power including PWM-controlled buck and boost regulators.
  • Quality documentation includes NCR, ECO, and MRB.

Job Duties

  • Troubleshoot and repair failed PCAs, PCBs, and end-item ACPs, REUs, AMUs, and subordinate subassemblies at the component level.
  • Read schematics in Altium and isolate faults to the component.
  • Perform hands-on rework, including soldering, rather than only writing a disposition for a technician.
  • Debug microprocessor circuits, including units that power up but have no SPI communication between the microcontroller and a peripheral.
  • Debug digital power supplies, including PWM, buck, and boost circuits, such as a buck regulator that is present but out of voltage under load.
  • Work a backlog of discrepant units, including groups with the same failure mode, and determine true root cause rather than only clearing volume.
  • Determine why units fail during testing on modern and legacy audio and avionics assemblies.
  • Debug automated test equipment fixtures and setups when the tester is down or giving bad results.
  • Identify design versus manufacturing issues and document them through NCR, ECO, and MRB.

Must-haves

  • Work onsite in Washington.
  • Component-level fault isolation and schematic debug on failed PCAs and PCBs.
  • Read Altium schematics.
  • Perform some board rework and soldering.
  • Troubleshoot microprocessor-based circuits, including SPI bus communication failures.
  • Troubleshoot digital power supplies, including PWM-controlled buck and boost regulators.
  • Debug fixtures and setups on automated test equipment.
  • Hands-on use of oscilloscopes, power supplies, multimeters, milliohm meters, a calibrator, flying probe, and ICT.
  • Own NCR, ECO, and MRB documentation.

Nice to Haves

  • Prior avionics, audio, or LRU experience, including legacy assemblies; transferable debug skills may substitute.
  • Experience with INSTEK, Tektronix or Rigol, Fluke, Sorenson, and HAKKO bench equipment; equivalent brands are acceptable.